Wet Look Stone Sealer

Application

DIRECTIONS FOR USE:

1. Always perform a test in an inconspicuous area on-site to check the suitability of the product, prior to use – read these instructions fully before application. Before application, the surface must be completely clean and dry.
2. To achieve colour enhancement: Apply a thin, even coat with a low-pressure sprayer, paint pad, natural fibre brush or sponge (we do not recommend using a roller as it makes the sealant ‘foam’ and can lead to an inconsistent, overly heavy application). Any excess sealer must be completely removed from the surface within 15-30 minutes to dry to a flat matt finish.
3. For ultimate wet look: apply a second coat after 60 minutes, with a thin and even application. Leave to dry on the surface (takes up to 12 hours to dry tack-free). The end result will be a high gloss, high colour-enhanced finish.
4. After application, it is important the stone surface is kept totally dry through the curing process (minimum 48 hrs). Please check the floor is tack-free and dry before foot traffic.

PLEASE NOTE:

Application range: 5°c – 20°c. Areas not to be sealed must be protected with masking materials.

EXPECTED WEAR

Under typical conditions, colour protection is guaranteed for 5+ years*. A top-up may be required to maintain a gloss finish due to typical footfall and abrasion. Effectiveness and longevity are reliant on correct application and maintenance. *2 coats required for optimal up-to 5-year protection.

COVERAGE:

Up to 25m2 per litre per coat.
Depending on surface porosity and texture.